NTXF4-FC/ NTX F4 Omnibus Flight Controller built in Ointergrated 600mw 5.8G Adjustable Transmitter
Descroption:
The flight controller uses Omnibus F4 firmware as its predecessor, equipped with STM32F405 processor , cooperate with MPU6000 six-axis sensor, and supports OSD adjustment function. Based on this, an additional 600MW 48CH 5.8G transmitter is added. There are independent 48 frequency points adjustable, and the transmission power of six gears is adjustable (PIT, 25MW, 100MW, 200MW, 400MW, 600MW). Reserved camera input, DSM / IBUS receiver input, PPM / SBUS input, LED_Strip output interface. The image transmission power supply adopts LC filter to reduce the interference of the motor to the image and built-in 5C/3A high-current BEC. Supports online adjustment of the Cleanflight/Betaflight firmware (default shipment is Betaflight firmware).
The receiver configuration, SBUS signal configuration RX6 input interface.
The DSM/IBUS receiver input configures RX1 as the input interface.
Factory firmware: betaflight_3.2.0_OMNIBUSF4SD
Main configuration:
Processor: STM32F405RGT6
Sensor: MPU6000
OSD video overlay: AT7456E
5.8G transmission picture transmission: 600MW 48CH six transmission power adjustable (PIT, 25MW, 100MW, 200MW, 400MW, 600MW)
Image transmission antenna interface: MMCX antenna base ( cable with SMA needle)
Receiver interface: DSMX and IBUS, PPM, SBUS
LED_Strip interface
BB ring/buzzer interface
Voide INPUT connector (5V)
SD card black box (self-provided SD card)
Reserved UART1, UART3, UART6 interface
LC filter
Built-in 5V 3A BEC
Supply voltage: 2-6S (7.4V-25.6V)
ESC signal support Dshot, Oneshot, Multishot, PWM
Board size: 36*36MM, screw hole spacing 30.5*30.5MM
Board weight: 8.7 g
